I've read numerous postings here about Apple AirPlay / Apple TV on this forum but still haven't been able to configure my 1042 AP correctly to do robust airplay. The ap is in autonomous mode, no controllers involved.
I have a working Cisco 871W that has absolutely no problems with AirPlay. The config on both (the wireless aspects) are the same.
It is a multicast issue; but I cannot get around this and make it work. Already tried the igmp snooping configured off and on. No difference. Have tried all latest IOS releases for the AP (12.4 / 15.2) but it just doesn't work correctly. If I shut down the AP and only have my 871W online everything is fine. If I only have the 1042 AP online airplay doesn't work, although at some very short moments, the iPad does seem to see the apple tv. Both APs share the same VLAN, no routing involved, plain layer 2.
Do any configurations exist that make the AP 1042 work with AirPlay? Is there a known bugid that I can track/trace? Should I open a TAC case for this?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...