I am having the same issue now with 1131s. All clients are actually getting a valid DHCP address, but for some reason, I cannot traverse the network. I cannot even ping the gateway. After a certain amount of time passes, I am able to ping the gateway and all is well. I am perplexed at this problem. Wired desktops do not have this issue.
Hi..Alex, is it because users are roaming? as for mine, i cant even recieve beacon comm between 1130 n the some users
(even i debug to the beacon level).
Is there anyone be able to provide expert advise? was it because of the users firmware or driver or etc?
Recently, i also encounter that CLI command and GUI configuration will varies abit in such that even after applying CLI command on the 1130 AP, the GUI does not reflect grahpically on the CLI command which had been executed on the same 1130AP. was it a bugs?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...