Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 1131 APs in HREAP mode producing output drops on interface of Switch

We have a 5508 controller on the latest code 7.0.98.0 and several Cisco 1131 access points.

Each of the access points are connected to a Cisco switch whether its a 2960 or 2975.

We are experiencing output drops from the interface that they are connected.

The config of the interface on the switch is very simple "switchport mode trunk"

We also have several Cisco 1252s that are on the same controller but are not having the same issue.

Any ideas?

Everyone's tags (4)
6 REPLIES
Cisco Employee

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

did we try using some other switchport connecting 1131??

Regards
Surendra

New Member

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

Yes, we have tried multiple ports on the switch.  We have about 15 Cisco 1131 access points all are giving the same output drops.

We have all of our APs in HREAP mode so that if the controller goes down we don't lose wireless clients.

We have several 1242 and 1252 Cisco APs that are not having this issue.

Thanks

Cisco Employee

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

did we try connecting the AP to the port on which the 1242 Aps are connected?? are we still observing the same??

Regards

Surendra

New Member

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

Yes, we have brought 3 types of access points into the computer room to observe the issue the 1131, 1242 and the 1252 and the only one that produces the output drops is the 1131.

We do have dynamic interfaces on the controller that correspond to the VLANs that the HREAP APs are in, I am not sure if this would be a problem or not.

Thanks

Cisco Employee

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

hmm.. nope that wont cause anything.. VLAN mappings done correctly for the remote vlan and also for the WLANs??

Regards
Surendra

New Member

Re: Cisco 1131 APs in HREAP mode producing output drops on inter

Yes, our controller is on vlan 1 and the AP is native to vlan 417

Here are some images.

Thanks

1128
Views
0
Helpful
6
Replies
CreatePlease to create content