We have a Cisco 1200 series access point, and we tried to do a firmware update. The update failed and the access does not seem to work now. The LEDs on the top blink in sequence: green, red, amber and it never stops. Resetting to factory defaults doesn;t seem to work. The firmware seems to be fine as all red LEDs are supposed to indicate an error with that. Any suggestions?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...