Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco 1230 access point a radio lightweight mode

Will the cisco 1230 access point work in lighweight mode if it is using a radio?

6 REPLIES
Hall of Fame Super Red

Re: cisco 1230 access point a radio lightweight mode

The 1230 can be upgraded to LWAPP with the A Radio model listed below;

Solution Requirements

Migration from autonomous access point mode to lightweight mode is possible on these Cisco Aironet access point platforms:

All 1130AG access points

All 1240 AG access points

For all IOS-based 1200 series modular access point (1200/1220 Cisco IOS Software Upgrade, 1210 and **1230 AP**) platforms, it depends on the radio:

if 802.11G, MP21G and MP31G are supported

if 802.11A, RM21A and RM22A are supported

The 1200 series access points can be upgraded with any combination of supported radios: G only, A only, or both G and A.

All 1310 AG access points

From this good doc;

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html

Hope this helps!

Rob

cisco 1230 access point a radio lightweight mode

AIR-AP1232AG-x-K9 (Cisco IOS Software)

AIR-LAP1232AG-x-K9 (Cisco Unified Wireless Network Software)

These products with Cisco IOS Software Release 12.3(11)JX or later  supported Lightweight Mode.

cisco 1230 access point a radio lightweight mode

You need to download

Cisco Aironet Upgrade Tool for Cisco IOS Software. Utility that upgrades IOS OS to LWAPP and retains current AP configuration. Requires Cisco Aironet Upgrade Image.

 

CiscoAironet-AP-to-LWAPP-Upgrade-Tool-v34.exe Cisco Aironet Upgrade Tool for Cisco IOS Software. Utility that upgrades IOS OS to LWAPP and retains current AP configuration. Requires Cisco Aironet Upgrade Image. 
CiscoAironet-AP-to-LWAPP-Upgrade-Tool-v34.exe

The link is -

http://software.cisco.com/download/release.html?mdfid=279537740&softwareid=280775089&release=3.4

Silver

cisco 1230 access point a radio lightweight mode

Yes and Kindly check the following link  for LAP support for 1230 AP

       http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6306/prod_bulletin0900aecd80321a2c_ps6521_Products_Bulletin.html

Cisco Employee

cisco 1230 access point a radio lightweight mode

I agree with Abhishek

Hall of Fame Super Gold

Re: cisco 1230 access point a radio lightweight mode

Will the cisco 1230 access point work in lighweight mode if it is using a radio?

Depends on what is your WLC.  It doesn't matter if you are using 802.11a radio module or not.

The final firmware version that supports 1230 is 7.0.220.X.  If you have a WLC that supports this firmware, then you are fine.  If you have, for example a WLC 2000 then the answer is "no". 

656
Views
0
Helpful
6
Replies