Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 1230 AP flash issue

Hi,

Post upgrade of our controllers to 6.0.199 two our our CiscoAP1231's didnt come back up and if we console into them it seems to be a flash error.

The device will no longer allow access to flash (DIR fails) and can't get the updated image.

I've tried the factory reset but it still has the same error.

Is there anyway to re-format the flash or is this likely to be a hardware failure?

thanks,

matt

Everyone's tags (3)
1 REPLY
New Member

Re: Cisco 1230 AP flash issue

I would try this: Setup a TFTP server with IP 10.0.0.2 and download the latest 1230 lightweight image since you are running 7.0.98. Rename the image file to "c1200-k9w7-tar.default" and place it in the TFTP root. Connect the 1230 AP to the TFTP server and hold the reset while powering the AP until the light turns red. This will boot the AP into rom mode and set the IP to 10.0.0.1. It will look for the TFTP server and download the image. The AP will reboot the new lightweight image.

602
Views
0
Helpful
1
Replies
CreatePlease to create content