Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO 1242 + WLC4402

Hi,

I have a controler 4402 with somes LAP1242, i want to know if the controler is shutdown, AP1242 lose his configuration or stay up and continue to operate ?

Thanks a lot

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: CISCO 1242 + WLC4402

4 REPLIES
Hall of Fame Super Gold

Re: CISCO 1242 + WLC4402

Hi Alexandrine,

Here's the gist of it all. By default, if you configure your WLC normally, the AP's run in a mode called "AP Mode". When this happens, if your one-and-only goes down for maintenance (like firmware upgrades), the AP's will stop and search for a controller until one is found.

However, if you operate in H-REAP mode, when your one-and-only WLC goes down AND your don't reboot your AP's, the AP's will operate normally.

Does this answer your question?

New Member

Re: CISCO 1242 + WLC4402

Thanks a lot for your quickly response

Hall of Fame Super Gold

Re: CISCO 1242 + WLC4402

Hall of Fame Super Gold

Re: CISCO 1242 + WLC4402

Thanks for the ratings. :)

504
Views
4
Helpful
4
Replies