My cisco 1310 bridge boot loader fail while i try to upgrade to newest firmware, not i m try to get back my boot loader , but seem to be tftp timed out error pls see the below message:
i try to get back my boot loader to C1310-k9w7-tar.123-8.jea3.tar. my tftp server ip is 192.168.5.2 and tftp version TFTPD32.323 bwlow is capture txt:
bridge: set IP_ADDR 192.168.5.3
bridge: set NETMASK 255.255.255.0
bridge: set DEFAULT_ROUTER 192.168.5.1
bridge: tar -xtract tftp://192.168.5.2/c1310-k9w7-tar.123-8.JEA3 flash:
tftp://192.168.5.2/c1310-k9w7-tar.123-8.JEA3: connection timed out
any advise please.
Solved! Go to Solution.
It appears that you are assigning IP address properly. For some reason we are not getting a response from TFTP server. This is typically one of 2 things:
1. Firewall on the TFTP server workstation
2. Connectivity issue between AP and TFTP server
I would check firewall settings on the TFTP workstation. Are you connecting the AP to the workstation directly or through a switch? If it is through a switch, you could plugin a different workstation to the AP switchport to make sure it could reach the server as well.
I have already off the firewall setting on tftp server workstation pls see attach. and pls be informed that i connect the AP directly to TFTP server workstation and not through switch. any other advise???
Do you have a TFTP server running? If so, how is it configured?
Can the AP ping the TFTP server?
I have assigned my TFTP server workstation IP 192.168.5.2/24 and gateway to 192.168.5.3 which i assign to my bridge via console, i also reply to ur PM. any further advise??
Gateway none means on tftp server workstation or on bridge ???
thks for replying my stupid questions.