All APs on remote light poles are enclosed in NEMA enclosures and are powered either through solar battery units and/or step-down transformers from the light pole power feed depending on that particular DC environment layout.
My issue is that the power tap from Cisco is only rated up to 260VAC. Our lights are at 277VAC. So I want to know if I can use a step down transformer to bring the power from the light down to a level where it won't burn out the power tap.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...