Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2700 Location Appliance

Deployed and setup for the first time. (4404,2700 and WCS). All the device are communicating to each other.Snmp v1/2 setup at the Controller pointing to WCS. The time of the devices are the same with ntp setup. All with the latest version Software. My problem is I can't see the clients from the Location Appliance. It won't show in the Map.

An assistant is greatly appreciated.

3 REPLIES
Silver

Re: Cisco 2700 Location Appliance

Did you add the maps to the WCS? Location appliance works in conjunction with the Cisco WCS. If the maps are not added to the WCS, the location appliance will not be able to track the clients.

New Member

Re: Cisco 2700 Location Appliance

Also be careful that snmp queries from the location app to the controller must be allowed.

New Member

Re: Cisco 2700 Location Appliance

Yes I did. After a few days posting my problem to the forum, I decided to open a tac case to cisco. They asked me to send some snapshots of the setting of my Location Appliance. Before I could reply with the settings there requesting, I able to resolve the issues. I was reading of how the Controller and Location Appliance communicate. Not only that time is very important for all Unified devices have to be syncronize, It was also the SNMP V3 needs to be properly configured or the SNMP v1/2 have to be set to 0.0.0.0 When I set my snmp ip to 0.0.0.0 then everything worked. Anyhow, thank you for the responce.

157
Views
0
Helpful
3
Replies