Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 5508 Hreap - slow wireless throughput

I have a Cisco 5508 setup at a host site with 3 other sites connected using hreap on 1252APs. When doing testing of network speed I find that the throughput from the wireless to wired network is at about 18mbps yet the same test  on wired side is 85-100mbps and wireless to wireless is 18mbps

Any ideas what could cause this                  

Everyone's tags (6)
4 REPLIES

Re: Cisco 5508 Hreap - slow wireless throughput

Hi Jeff,

do you use local switching in hreap mode?

If you are tunneling traffic back to WLC WAN connection could be your limiting factor.

HTH

Sebastian

Sent from Cisco Technical Support iPad App

New Member

Cisco 5508 Hreap - slow wireless throughput

It is set to local swiching for each of the five vlans setup- a tracert shows correct path from point a to b

Re: Cisco 5508 Hreap - slow wireless throughput

Hm, just guessing is hard. So ...

Can you upload the configuration?

Which standard do you use? .11n? Encryption method?

Where you the only one on ap while taking the tests?

Have you tried some tests at various daytimes?

Any chances to check for interference or change channels?

Sebastian

Sent from Cisco Technical Support iPad App

Re: Cisco 5508 Hreap - slow wireless throughput

as well, what type of switchport is the AP connected to?  10/100 or 10/100/1000

HTH,
Steve

-----------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
826
Views
0
Helpful
4
Replies