Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 881G: Set Encapsulation on Cellular interface

Hi All,

I am configuring a Cisco 812G and 881G. the part number is C812G+7-K9 & C881G+7-K9. The IOS version is 15.2 (2r) T.

when i get to the cellular interface i am not able to set the encapsulation to be PPP. It only support SLIP.

Do have any idea on how to set PPP on the Cellular interface?

Eric

1 REPLY
VIP Purple

Cisco 881G: Set Encapsulation on Cellular interface

HI eric,

It does not support encap PPP. However, there is no issue using encap SLIP though. From my research it shouldn't be an issue because the encapsulation is apparently used for the communication between IOS and the modem firmware... as explained in this following post

https://supportforums.cisco.com/docs/DOC-18957

Reagrds

Dont forget to rate helpful posts

137
Views
0
Helpful
1
Replies