Cisco Aeronet 1131AG with controler

[tonderai.chinowona]

Hi guys. iam new to the aeronet 1131ag AP. it had an association with a controller wich is not there at all.My problem is, how do i reset the configs to default.the other thing is that i cannot configure it, its indicating an error messege ERROR!!! Command is disabled.i tried looking on the website and cant get any info

[Leo Laohoo]

To set the AP to factory default, you need to run the Autonomous IOS (aIOS). Follow the documentations below for the procedures:

Password Recovery Procedure for the Cisco Aironet Equipment

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml

Hope this helps.

[Scott Fella]

Console into the AP then follow the following steps:

First, check the flash:

lap_1131#dir

Directory of flash:/

2 -rwx 279 May 09 2008 11:52:20 +00:00 env_vars

4 -rwx 6168 May 09 2008 11:52:20 +00:00 private-multiple-fs

6 drwx 256 May 09 2008 11:49:05 +00:00 c1130-k9w8-mx.124-3g.JA2

5 drwx 128 Mar 01 2002 00:03:43 +00:00 c1130-rcvk9w8-mx

15998976 bytes total (10716672 bytes free)

Then delete the LWAPP image:

lap_1131#delete /r /f flash:/c11310-k9w8-mx.124-3g.JA2

Not the one the has rcv in it!!!!!!

Thirdly reload the AP:

lap_1131#reload

Then issue a clear lwapp private-config

You'll end up with a clear AP.