Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Aeronet 1131AG with controler

Hi guys. iam new to the aeronet 1131ag AP. it had an association with a controller wich is not there at all.My problem is, how do i reset the configs to default.the other thing is that i cannot configure it, its indicating an error messege ERROR!!! Command is disabled.i tried looking on the website and cant get any info

2 REPLIES
Hall of Fame Super Gold

Re: Cisco Aeronet 1131AG with controler

To set the AP to factory default, you need to run the Autonomous IOS (aIOS). Follow the documentations below for the procedures:

Password Recovery Procedure for the Cisco Aironet Equipment

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml

Hope this helps.

Hall of Fame Super Silver

Re: Cisco Aeronet 1131AG with controler

Console into the AP then follow the following steps:

First, check the flash:

lap_1131#dir

Directory of flash:/

2 -rwx 279 May 09 2008 11:52:20 +00:00 env_vars

4 -rwx 6168 May 09 2008 11:52:20 +00:00 private-multiple-fs

6 drwx 256 May 09 2008 11:49:05 +00:00 c1130-k9w8-mx.124-3g.JA2

5 drwx 128 Mar 01 2002 00:03:43 +00:00 c1130-rcvk9w8-mx

15998976 bytes total (10716672 bytes free)

Then delete the LWAPP image:

lap_1131#delete /r /f flash:/c11310-k9w8-mx.124-3g.JA2

Not the one the has rcv in it!!!!!!

Thirdly reload the AP:

lap_1131#reload

Then issue a clear lwapp private-config

You'll end up with a clear AP.

-Scott
*** Please rate helpful posts ***
362
Views
0
Helpful
2
Replies