08-23-2012 02:37 PM - edited 07-03-2021 10:34 PM
Hello Group,
I have a 3602i access point and have been looking to see if it was possible to load a Mesh AP image on the AP?
Solved! Go to Solution.
08-23-2012 03:08 PM
Marcus,
You dont "load" code, rather you change the mode of the AP to bridge mode.
08-23-2012 03:08 PM
Marcus,
You dont "load" code, rather you change the mode of the AP to bridge mode.
08-24-2012 06:26 AM
Thank you George for sharing your knowledge.
08-23-2012 03:40 PM
Hello,
Agree with George. You can set the ap to mesh by changing its mode to bridge. you can change the mode from gui:
Wireless -> your ap -> ap mode.
HTH
Amjad
Sent from Cisco Technical Support iPad App
08-24-2012 06:28 AM
Thanks for the assistance Amjad!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide