Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco AIR-CAP3602I access point conversion

                   Hello Group,

I have a 3602i access point and have been looking to see if it was possible to load a Mesh AP image on the AP?

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Cisco AIR-CAP3602I access point conversion

Marcus,

You dont "load" code, rather you change the mode of the AP to bridge mode.

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
4 REPLIES

Cisco AIR-CAP3602I access point conversion

Marcus,

You dont "load" code, rather you change the mode of the AP to bridge mode.

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
New Member

Re: Cisco AIR-CAP3602I access point conversion

Thank you George for sharing your knowledge.

Re: Cisco AIR-CAP3602I access point conversion

Hello,

Agree with George. You can set the ap to mesh by changing its mode to bridge. you can change the mode from gui:

Wireless -> your ap -> ap mode.

HTH

Amjad

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
New Member

Re: Cisco AIR-CAP3602I access point conversion

Thanks for the assistance Amjad!

1172
Views
0
Helpful
4
Replies