07-23-2007 05:32 AM - edited 07-03-2021 02:22 PM
firmware installed 123-8.JEB
Hello,
I use NET-SNMP to take information from AP's database agent.
I want the following information:
client rates (Mbps) - the current rate of
every client connected to the access point. For example for 3 clients -> 1Mbps,5.5Mbps, 11Mbps
I have searched all the supported MIBS from Cisco's website but i cant find anything...
Do i miss something??
Can you help plz...
Best regards,
Theodoros Dionysiou
07-27-2007 12:34 PM
There are no MIBs available > YOu can know the data rate from the client utility themselves.You can also use Protocol analyzer or link test on the client utility to know the data rates.
07-27-2007 11:16 PM
Hello again,
I have found what i needed.
CISCO-DOT11-ASSOCIATION-MY.my
Object : cDot11ClientCurrentTxRateSet
This object gives the information about the current rate that the access point sends data to the client.
I have tested this and it's correct.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: