please help .im new to the wireless world . I have Cisco AP 1260 . it was connected to WLC . the WLC is down now and im trying to configure the Ap as stan alone AP . but when im trying to acccess the HTTP is giving me the error in the picuter attached . the image on the flash is
You have a little bit of a road ahead buddy. You need to download the 1260 autonmous code first and flash the AP. This turns it into an autonmous AP. Once done then you need to configure the AP for your network.
If you want this to go into HREAP mode, you need to connect to the WLC and configure for HREAP (FLEX). If its down, there isnt much you can do until you get the WLC up.
Whats wrong with the WLC?
__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin __________________________________________________________________________________________ "I'm in a serious relationship with my Wi-Fi. You could say we have a connection."
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...