12-27-2011 06:02 AM - edited 07-03-2021 09:18 PM
Is it possible to use Cisco Band Select on a Cisco 5508 WLAN controller and still disable the 802.11b data rates?
Solved! Go to Solution.
12-27-2011 07:57 AM
Yes, you can disable the 'b' data rates and still get the band select, so long as the radio policy in the WLAN is set to all.
HTH,
Steve
----------------------------------------------------------------------------------------------------------
Please remember to rate helpful posts or to mark the question as answered so that it can be found later.
12-27-2011 07:03 AM
Hi Ryan,
This was tested by Jim in this good thread
https://supportforums.cisco.com/message/3236497#3236497
Cheers!
Rob
12-27-2011 07:57 AM
Yes, you can disable the 'b' data rates and still get the band select, so long as the radio policy in the WLAN is set to all.
HTH,
Steve
----------------------------------------------------------------------------------------------------------
Please remember to rate helpful posts or to mark the question as answered so that it can be found later.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: