Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Band Select and Data Rates

Is it possible to use Cisco Band Select on a Cisco 5508 WLAN controller and still disable the 802.11b data rates?

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Cisco Band Select and Data Rates

Yes, you can disable the 'b' data rates and still get the band select, so long as the radio policy in the WLAN is set to all.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
2 REPLIES
Hall of Fame Super Red

Cisco Band Select and Data Rates

Hi Ryan,

This was tested by Jim in this good thread

https://supportforums.cisco.com/message/3236497#3236497

Cheers!

Rob

Cisco Band Select and Data Rates

Yes, you can disable the 'b' data rates and still get the band select, so long as the radio policy in the WLAN is set to all.

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1095
Views
10
Helpful
2
Replies