06-19-2014 12:16 AM - edited 07-05-2021 01:02 AM
we have network with nexus 7009 core and a module ML-148GS-11L
we are deploying cisco wireless in the netowrk. wlc 2504 and AP 2602I
wlc 2504 connect direct to ML-148GS-11L (trunk)
interface Ethernet5/35
switchport
switchport mode trunk
no shutdown
If I connect AP 2600 through a swith 2960 which trunk with ML-148GS-11L, the AP register with wlc2504 and client can connect to wireless network
If I connect AP 2600 connect direct to ML-148GS-11L (edge port, access), the AP register with wlc2504 but client cant see any SSID.
interface Ethernet5/37
switchport
switchport access vlan 99
spanning-tree port type edge
no shutdown
Does the module switch not compartible with AP 2600 ?
Regrads,
06-19-2014 12:50 AM
You will probably not see the SSID because the M1 line card is NON-PoE.
06-19-2014 02:29 AM
06-19-2014 05:13 AM
Ok, if the APs are UP and registered to the WLC:
1. Is the SSID broadcasted in both 802.11a and 802.11b radios?
2. Do you have "Broadcast SSID" enabled?
3. Is the AP in the correct AP-Group?
06-19-2014 06:47 PM
hi Leo,
1. SSID broadcast all radios
2. "Broadcast SSID" enabled
3. All AP in default-group
and client cant get SSID from the AP which connect to M1 line.But at the same time, the client can connect to other APs which connected to nexus through a 2960x switch.
06-21-2014 02:48 AM
AndThe AP work well if I connect with the M1 line through Fabric 2248TP
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: