Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cisco nexus 7000 swith module and cisco AP 2600

we have network with  nexus 7009 core and a module  ML-148GS-11L 

we are deploying cisco wireless in the netowrk. wlc 2504 and AP 2602I

wlc 2504 connect direct to ML-148GS-11L (trunk)

interface Ethernet5/35

  switchport
  switchport mode trunk
  no shutdown

If I connect AP 2600 through a swith 2960 which trunk with ML-148GS-11L, the AP register with wlc2504 and client can connect to wireless network

If I connect AP 2600 connect direct to  ML-148GS-11L (edge port, access), the AP register with wlc2504 but client cant see any SSID.

interface Ethernet5/37
  switchport
  switchport access vlan 99
  spanning-tree port type edge
  no shutdown

Does the module switch not compartible with AP 2600 ?

Regrads,

 

 

5 REPLIES
Hall of Fame Super Gold

You will probably not see the

You will probably not see the SSID because the M1 line card is NON-PoE.

New Member

All my ap use power injector.

All my ap use power injector. Anh the ap registed to the wlc
Hall of Fame Super Gold

Ok, if the APs are UP and

Ok, if the APs are UP and registered to the WLC:  

 

1.  Is the SSID broadcasted in both 802.11a and 802.11b radios? 

2.  Do you have "Broadcast SSID" enabled?

3.  Is the AP in the correct AP-Group?

New Member

hi Leo,1. SSID broadcast all

hi Leo,

1. SSID broadcast all radios

2. "Broadcast SSID" enabled

3. All AP in default-group

and client cant get SSID from the AP which connect to M1 line.But at the same time, the client can connect to other APs which connected to nexus through a 2960x switch.

New Member

And I can The AP work well if

AndThe AP work well if I connect with the M1 line through Fabric 2248TP

196
Views
0
Helpful
5
Replies
CreatePlease login to create content