I'm looking at deploying Cisco 1552s in point to multipoint mode. I would like to know if its possible to connect wireless clients directly to the the mesh AP when in point to multipoint mode?
From the documentation (Listed below), Wireless Backhaul mode allows wireless clients to connect to the mesh AP 2.4Ghz radio while using 5Ghz radio for the point to point backhaul link. Can you also connect Wireless clients to the mesh AP in a point to multipoint solution?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...