Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Spectrum Expert

I have downloaded Cisco Spectrum Expert and installed on a dell notebook running windows8.

Then I started looking for a sensor card.

I hav gotten Cisco Spectrum Expert Wi-Fi (CardBus) - AIR-CSCO-SE-WIFI-C reference and I am concerned with 2 facts.

1. dell notebook does not have a compatible interface to attach this card;

2. it is a very expensive card.

 

Is there any other sensor card interface compatible with dell xps 12?

Thanks in advance.

Rosa

2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

You can use a Cisco AP in "SE

You can use a Cisco AP in "SE-Connect" - Spectrum Expert mode as the sensor. In this way you do not require any compatible cards

here how you do it

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010001100.pdf

HTH

Rasika

**** Pls rate all useful responses ****

 

Hall of Fame Super Gold

You may need to use a PCMCIA

You may need to use a PCMCIA-to-USB card.

 

8 REPLIES
VIP Purple

You can use a Cisco AP in "SE

You can use a Cisco AP in "SE-Connect" - Spectrum Expert mode as the sensor. In this way you do not require any compatible cards

here how you do it

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_010001100.pdf

HTH

Rasika

**** Pls rate all useful responses ****

 

New Member

Thanks a lot.I would be great

Thanks a lot.

I would be great if it is possible to use AP as sensor.

It is a less expensive.

Rosa

 

New Member

Hi,

Hi,

I wanted to use a 3702i autonomous AP in spectrum mode. But it does not show any devices and all it shows is "waiting for devices". I read somewhere that only the spectrum exert card shows devices. Is this true?

Abebe

Hall of Fame Super Gold

You may need to use a PCMCIA

You may need to use a PCMCIA-to-USB card.

 

New Member

Thanks Leo.I will try  to use

Thanks Leo.

I will try  to use AP as sensor.

It is a less expensive option.

Rosa

Hall of Fame Super Gold

Rosa, Talk to your SE.  If

Rosa, 


Talk to your SE.  If the PCMCIA card is un-used, you may be able to return it or get a credit.

 

Thanks for taking the time to rate our posts.  :)

New Member

I have configured AIR

I have configured AIR-CAP3502I-A-K9  AP Mode as SE-CONNECT for using Cisco Spectrum Expert 4.1.

Cisco Spectrum Expert shows Spectrum AQ, Spectrum (2) graphs.

It can not show devices. In Active Devices:

... Waiting for Devices ...

Channel Summry sows incomplete as no APs are found.

Any idea?

 

New Member

It is running fine.In fact

It is running fine.

In fact there is few interference where ap is depoyed.

I have already seen a bluetooth piconet device.

557
Views
0
Helpful
8
Replies