Is it possible to create a virtual interface in Cisco's Aironet device for the management purpose. For example, I like to create following vlans:
Vlan 2 for Managment
Vlan 3 for data
Vlan 4 for voice
With the basic layer 2 concept, for example, Cisco 2950 switches, one can create virutal interface,
and assign an ip address for the managment purpose. Can same thing be done with Wireless box?
From the Web GUI, express setup page, I can assign an IP Address, but this is not what I want to do. I like to create a virtual interface 2 and then assign an IP address. Is it possible from gui or even
Please refer to a good link for step by step configuration, if possible
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...