Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco WAP200

How I can configer Point to Multipoint Bridge ?

one WAP200 Bridge --> Two WAP200 Bridges in different buildings.

1 REPLY
New Member

Re: Cisco WAP200

You can't - it's not a bridge, it's an AP. There are fundamental differences between bridges and APs. You CAN however use two Cisco 1242 APs to do this as they support bridging as well as AP mode. What you want is WET200 - a slight difference in model number, big difference in capabilities.

Regards,

Scott

500
Views
0
Helpful
1
Replies