I have done an audit on the configuration group that our WiSMs are in, which shows up some differences. I would like to investigation on what the actual differences in the attribute values are between the controllers and the templates in each case. I get an error message shown in the first attachment (Failed to contact server. Please make sure you are logged in and have network connectivity).
The version of WCS is 22.214.171.124, and so is the software on the WiSM. The WCS can talk to the WiSM, and so can I. Can you please advise what how this issue can be fix.
I opened a TAC SR to check but the problem later disappeared without doing anything from my side. We got the TAC SR closed without doing anything. ( we captured traffic and collected logs but the problem is resolved before the engineer analyzes the traffic).
I suggest that you wait about a week and open a TAC cae if the issue persists.
One more thing I just remembered: in my case the configuration was identical but it shows is as mismatch and when try to audit it gives the error.
Btw, what is your WCS version?
Sent from Cisco Technical Support iPad App
Rating useful replies is more useful than saying "Thank you"
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...