Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco Wireless Multicast Setup, One Subnet, To Enable Apple AirPlay

Hi,

I’m having issues with enabling Apple’s AirPlay services on a relatively simple network consisting of a Cisco 881 (Advanced IP Services) and an autonomous Cisco 1142 AP. I’ve attached a diagram explaining the connectivity. I believe I have to enable IP Multicast at the router, but I’m not really sure the best/right way to do it. Also I’m not sure what/if any commands would be needed at the AP.

All of the wireless clients are confirmed to be in the same subnet, so no real routing is happening etc. Also regular Internet connectivity/routing from the wireless clients is fine.

Any help would be greatly appreciated. Thanks.

Everyone's tags (5)
5 REPLIES
Hall of Fame Super Silver

Re: Cisco Wireless Multicast Setup, One Subnet, To Enable Apple

There are other threads on this, but this one might help

https://supportforums.cisco.com/message/3520397#3520397

This will explain on the switch side:

https://supportforums.cisco.com/docs/DOC-24187

-Scott
*** Please rate helpful posts ***
New Member

Cisco Wireless Multicast Setup, One Subnet, To Enable Apple AirP

Thanks for the two URLs. The first might be promising, but the second involves a WLC which I don't have. This is where I'm essentially getting stuck R.E. configs for both my wired 881 and my autonomous 1142.

Hall of Fame Super Silver

Re: Cisco Wireless Multicast Setup, One Subnet, To Enable Apple

The second link has a small section on the wired multicast side.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: Cisco Wireless Multicast Setup, One Subnet, To Enable Apple

Here is another thread for the 1142.

https://supportforums.cisco.com/thread/2093036?tstart=0#3393570

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
New Member

Cisco Wireless Multicast Setup, One Subnet, To Enable Apple AirP

I've tried the commnd [ no ip igmp snooping ] on the AP. Still nothing. I've also enables Multicast routing on the 881 using:

881(config)# ip multicast-routing

881(config-int vlan50)# ip pim dense-mode

Still nothing...

8741
Views
0
Helpful
5
Replies