Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco WLC 5508 - WLAN Per-User Bandwidth Contracts

Hi,

I setup per-user bandwidth contracts on my guest anchor controller. The controller model is 5508 and firmware is 7.4.121.0.  No Qos settings were configured on the foreign controllers.

 

The bandwidth limits for the WLAN worked correctly for a couple of weeks, then speed reduced to almost nothing. I removed the WLAN bandwidth limits and speed was back to normal again.

 

Has anyone else run into this issue? Any ideas why it might have happened?

 

Thanks,

 

 

387
Views
0
Helpful
0
Replies