Cisco WLC Controllers in the same network

[beejrteek]

Hi All,

I have a one question. If it possible to run two Cisco WLC Controllers in the same subnet network ? I asking you because at this moment I have one WLC but it support only 25 AP and this licence pool has completely run out. I have additional Cisco WLC with 5 AP support. Can I put new WLC to the same network where old WLC working ?

[Rasika Nayanajith · Accepted solution]

Yes, you can. Make sure you configure same mobility group name , rf-group name & virtual interface IP in both WLCs with mobility peering.

You can control which WLC is primary & which one is secondary for a given AP under High Availability tab of AP configuration.

HTH

Rasika

**** Pls rate all useful responses ****

[beejrteek]

Thanks !! :)

Best regards,

Bartek

[beejrteek]

I have additional question. So If I have Cisco WLC 2504 with support 25 AP, it is possible to increase number AP from 25 to 30 through buy additional licence for 5 AP and install this licence on Cisco WLC?

[Rasika Nayanajith]

YES,

If you get 5 AP adder licences (something like L-LIC-CT2504-5A), you should be able to increase AP count from 25-30

HTH

Rasika

**** Pls rate all useful responses ***