Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clearing a MAC address ACL using CLI

We're getting an error when we try to use the GUI to add and remove MAC addresses from a our ACL for filtering purposes. Cisco's doc says that we need to delete or clear the existing ACL using the CLI in order for us to get rid of the error message showing up in the GUI.

Any help would be appreciated.

1 REPLY
Hall of Fame Super Red

Re: Clearing a MAC address ACL using CLI

Hi Bill,

This is a very helpful doc;

Access Point ACL Filter Configuration Example

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008058ed26.shtml#macbasedacls

Hope this helps!

Rob

336
Views
0
Helpful
1
Replies