Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Clearing old AP names on WCS

when I go to monitor/access points I see access point names that are not the real names. Some will be called AP0023.0425.05ba and when I look on my controller there is no AP0023.0425.05ba.

How can I clear out the access point list and make it refresh its self?

1 REPLY

Re: Clearing old AP names on WCS

Configure -> controllers

Refresh config from controllers.

When asked to retain or delete previous settings, choose delete.

113
Views
0
Helpful
1
Replies