Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CLI command to asign the primary controller name and IP from the master controller.

I´m looking for the CLI command to asign the primary controller name and IP from the master controller. So as AP's join the master controller, I can move them to their new Controller. I would like to do this thru the CLI of the master controller when I rename the AP's with a script that I write after inventorying them.     Thanks to all who have any knowledge on this CLI command.

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Command:  config AP primary

Command:  config ap primary <WLC name> <AP Name> <WLC Management IP address>

Hall of Fame Super Gold

Hi Mark,  Can you please mark

Hi Mark, 

 

Can you please mark this post as "Answered" if the recommendation has fixed the issue?  

3 REPLIES
Hall of Fame Super Gold

Command:  config AP primary

Command:  config ap primary <WLC name> <AP Name> <WLC Management IP address>

Community Member

Leo Laohoo Thanks so mush it

Leo Laohoo

 

Thanks so mush it's a lot easier to assign controller to a large group of new AP's this way.

I used this command from the master controller to change them to the NEW controller.

 and it works GREAT...

(Cisco Controller) >config ap primary-base <WLC name> <AP Name> <WLC Management IP address>

Hall of Fame Super Gold

Hi Mark,  Can you please mark

Hi Mark, 

 

Can you please mark this post as "Answered" if the recommendation has fixed the issue?  

139
Views
0
Helpful
3
Replies
CreatePlease to create content