Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLI of AP1200 is strange

Which is the problem when the CLI is like this? and what do I have to make?

ap:

ap: ?

? -- Present list of available commands

arp -- Show arp table or arp-resolve an address

boot -- Load and boot an executable image

cat -- Concatenate (type) file(s)

clear_ether -- clear ethernet port statistics

copy -- Copy a file

delete -- Delete file(s)

dir -- List files in directories

dump_save_regs -- dump saved regs in OCM

etest -- test emac driver code

ether_init -- initialize ethernet port

flash_init -- Initialize flash filesystem(s)

format -- Format a filesystem

fsck -- Check filesystem consistency

help -- Present list of available commands

init_pci -- initialize pci bridge

led_test -- cycle led patterns

memory -- Present memory heap utilization information

mkdir -- Create dir(s)

more -- Concatenate (display) file(s)

rename -- Rename a file

reset -- Reset the system

-- MORE --

1 REPLY
New Member

Re: CLI of AP1200 is strange

You have a cod issue. that is rommon for a 1200. Look in the recovering from failure section here and it should help.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

121
Views
0
Helpful
1
Replies
CreatePlease login to create content