Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Client Configuration

i have two controllers 4402and 15 WAP 1250s with both radio AGN

i need to configure the client to support maximum Speed

please advice what is the best Practice configuration for Both WLC and client

(the maximum speed for 2.4Ghz GN-radio)

the Laptop and driver Detail

DELL wireless 1510 wireless-N WLAN

Driver Provider :Broadcom

Driver Date :3/21/2008

:4.170.77.3

1 REPLY
Gold

Re: Client Configuration

Make sure you use either WPA2/AES or an open WLAN and have WMM enabled. Getting the full possible 300Mbps data rates are not going to be advisable on the 2.4GHz range because this requires channel bonding. Setting up channel bonding on the 2.4GHz radios will cause co-channel interference between every AP as they all will be using channel 6.

161
Views
0
Helpful
1
Replies
CreatePlease to create content