Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Client Load Balancing with a failover pair of 4402 controllers?

On page 10-4 of the Cisco Wireless LAN Controller Configuration Guide (Software Version 4.0) under the section about Client and Network Load Balancing is the following note:

"Client load balancing works only for a single controller. It is not operate in a multi-controller

environment."

My question is as follows:

In a small environment where all access points are connected to a single primary controller and a second controller is only participating in the mobility and RF groups as a backup in the event of primary controller failure, will client load balancing work?

Thank you,

- Brad

109
Views
0
Helpful
0
Replies