Clients are randomly dropping and will not connect back to the AP
We have clients that will randomly disconnect from an AP and then cannot connect again until the AP is rebooted. We have unselected exclusions and they are not going into an excluded clients list. Any ideas?
Re: Clients are randomly dropping and will not connect back to t
Sorry this seemed to happen after we upgraded to 6.0.188. It probably has
effected over 600 clients, but all randomly it will effect just one person and multiple people will be connected to the ap just fine. After the upgrade we made an a ssid that they were all connected to and when we say the problem we switched them to g ssid. We then just made one ssid a/b/g but it still seems to be happening.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...