Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Combining lightweight accesspoint and Autonomous accesspoint

Looking for a controller that can manage

AIR-AP1242AG-E-K9 &

AIR-LAP1142N-E-K9

4 REPLIES
Hall of Fame Super Silver

Re: Combining lightweight accesspoint and Autonomous accesspoint

You can use any WLC to manage LAP's, it just depends on how many LAP's. You can also convert the 1242's to LAP's so you can manage them also.

Upgrade autonomous to LWAPP

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

Wireless LAN Controllers

http://www.cisco.com/en/US/products/ps6302/Products_Sub_Category_Home.html

-Scott
*** Please rate helpful posts ***
Gold

Re: Combining lightweight accesspoint and Autonomous accesspoint

The WCS can monitor/manage autonomous and lightweight AP's as of 5.0 and later.

Bronze

Re: Combining lightweight accesspoint and Autonomous accesspoint

I have a WCS 6.0.132.0 that I just built and added a few of my autonomous AP's. From what I've seen, about all you can do with them is upgrade the IOS and convert them to lightweight. Doesn's seem to show the correct Tx power leverl (always 5) or the correct client count.

Hall of Fame Super Gold

Re: Combining lightweight accesspoint and Autonomous accesspoint

Here's some documentations for you to peruse.

Cisco Wireless LAN Controller Configuration Guide, Release 6.0

http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/Controller60CG.html

Hope this helps.

181
Views
0
Helpful
4
Replies
CreatePlease to create content