Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Command to save config on 1142 LAP?

I am trying to assign a static ip and default gateway to my LAP through the CLI, but after I reboot it, I lose the config and it reverts back to dhcp.

Is there any command to save the config to the AP through the CLI?  I've tried all I can think of (i.e. wr mem, copy run start, etc...) and have looked throught the available commands but cannot figure out a way to do it...

Thanks,

Everyone's tags (1)
6 REPLIES

Command to save config on 1142 LAP?

yup, either a wr, wr mem should do it.  Unless the confreg has been changed for some reason.

When you boot in, do a dir flash: and you should see the config.txt

HTH,

Steve

----------------------------------------------------------------------------------------------------------

Please remember to rate helpful posts or to mark the question as answered so that it can be found later.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Command to save config on 1142 LAP?

On Autonomous AP's it works fine, but on all my LWAP's I get this error...

AP30e4.dbd9.4ea2#wr mem                    

Building configuration...

[OK]

NVRAM Verification Failed

AP30e4.dbd9.4ea2#

Command to save config on 1142 LAP?

ahh.  yeah, you can't do that on the CUWN AP.  Once it joins the WLC you can set the IP address and save it from there.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Hall of Fame Super Gold

Command to save config on 1142 LAP?

You can't configure anything on an LWAP/CAPWAP IOS of a WAP.  That's the not a bug.  It's a the intention to use a WLC to do configuration.

Use the process below to convert your WAP from CAPWAP/LWAP into autonomous.

Using a TFTP Server to Return to a Previous Release

New Member

Command to save config on 1142 LAP?

There's actually quite a bit you can configure on a LAP via the CLI. It's especially helpful when you're trying to troubleshoot issues.  You just can't *save* anything via CLI through the traditional commands..

I'm sure there is a way to save some of that config so I didn't have to paste it back in after each reboot.  I know they are meant to be configured via the controller, but when they aren't joining, aren't getting an IP address, or for other issues, it'd be really nice to save the basic config manually on the CLI.

Command to save config on 1142 LAP?

There's not anyway to save that config.  Even if you use the debug capwap con cli to get access to all of the commands.  You still can't save it.

Now if you just need it to hold an IP address you can use the capwap ap ip address command, and it should hold that through a reboot.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
4529
Views
0
Helpful
6
Replies
CreatePlease login to create content