Commands to upgrade MSE

[Alejandro.Angon]

HI,

I have download MSE software image using Prime, and I show, that I need to run the upgrade via MSE CLI, but I don´t understand the upgrade procedure from the Release Note document, do you know which commands I need to run?

thanks

[Rasika Nayanajith · Accepted solution]

Hi

Please refer this & see if that helps. It describe both WCS/Prime & CLI options for MSE software upgrade

http://www.cisco.com/c/en/us/td/docs/wireless/mse/3355/user/guide/mse3355_qsg/mse_qsgmain.html#wp1124555

HTH

Rasika

**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****

[Alejandro.Angon]

I have run the command ./CISCO-MSE-L-K9-7-6-120-0-64bit without stopping the service and software was reistalled successfully. Now the problem is that Prime don´t see MSE reachable. I made an MSE backup and I was looking for the process to restore MSE form that file, but I have been able to find the process. does any one know how to restore MSE?

thanks

[Alejandro.Angon]

Hi,

After delete old MSE form Prime and run /opt/mse/setup/setup.sh command on MSE, set the NCS user and password to default, I could add again MSE and restore it uploading the backup file to Prime disk:/defaultRepo directory and use the manteinance and restore option from Prime for MSE