a) your running kernel and your kernel source are the same version (2.4.2-4GB)
b) you have turned off all PCMCIA/CardBus support in the kernel under "General Setup",
c) you have disabled all PCMCIA/Pocket and Portable Adapters in the kernel under "Network Device Support," then "Ethernet (10 or 100Mbit)"
d) you have appropriate networking options to allow DHCP traffic under "Networking Options," if you're going to do DHCP.
The documentation for the Linux Aironet driver assumes that one has read the HOWTO & readme for PCMCIA which says all this, and that one knows how to recompile one's kernel. The issue has been raised with the documentation folks.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...