Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuration Distribution

Hi,

We have a setup of around 15 Nos of AP1200 running IOS 12.01T1,with 802.1x - PEAP enabled.

The problem we are facing is when we do some changes in configuration like adding a new vlan on one AP and try distributing the configuration using the Distributing a Configuration option,we are not able to see in the list all the 15 APs,we are able to see only 7 to 8 APs and it results in an error for all these 7 to 8 APs.

We are using the same user which has been created on all APs with similar rights,to distribute the configuration and all other configurations like web server are done correctly.

Pls let me know the reason or causes for this or are we missing any configuration ?

Regards,

Jagadish S

4 REPLIES
Bronze

Re: Configuration Distribution

Distributing configuartion work by the help of multicast , check out whether the switch used for this supports Multicast. Check out for traffic with IP address 224.1.0.1 and 224.0.1.40 with a sniffer trace. You can have a look at this document too.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a008010f634.html

New Member

Re: Configuration Distribution

Hi,

I have checked that multicast is enabled on all the switches.Also the configuration is getting updated on few AP's even though it says an error on the distributing AP.

Pls help me resolving this issue.

Regards,

Jagadish S

New Member

Re: Configuration Distribution

Hello jagadish

got the same problem with 350 APs running VxWorks.

Solution was to set on all the same default Gateway.

The factory default gateway 255.255.255.255 did not work.

I'm absolutely sure that this was an AP issue because i tried it on hubs and different switches.

kind regards

Hermann

New Member

Re: Configuration Distribution

Hi Hermann,

I have set the same default gateway on all AP's,but still the problem persists.

Regards,

Jagadish S

206
Views
0
Helpful
4
Replies
CreatePlease to create content