Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configure access point AIR LAP1131-G-E-K9

the LAP was reset to default using the mode button. It already has an lwapp image downloaded from the controller on it. I cannot reconfigure it with IP address and controller IP address. Command disabled message is obtained

3 REPLIES
Hall of Fame Super Gold

Re: configure access point AIR LAP1131-G-E-K9

You can't configure an AP when it's on Lightweight mode. If you want to configure the IP Address it has to be on Autonomous mode.

Does this help with your question?

New Member

Re: configure access point AIR LAP1131-G-E-K9

I uploaded an autonomous image on the AP but I do not get the lwapp ip addrress command so that I can configure a static Ip address on the device. Can you help me out?

Hall of Fame Super Gold

Re: configure access point AIR LAP1131-G-E-K9

Here's a silly question: Is the AP running the newly uploaded Autonomous IOS?

Lightweight IOS always have a "rcv" prefix in the filename.

1420
Views
0
Helpful
3
Replies
CreatePlease to create content