Configuring External DHCP on the access Switches for Flexconnect and Local AP's
I will be implementing the design as per the attached diagram. The two sites are around 500 meters apart and are connected through an access port ( not trunk). They cannot be put in trunk as the client will not allow us to. Please refer to the diagram attached.
I thought of doing internal DHCP for both remote AP's (flexconnect) and local AP's but I read that internal DHCP servers are not supported when using HA AP SSO on the wlc 5508. Since I'll be using that, there is no point using internal DHCP's.
Now since I'm new to external DHCP connected to controllers, can you please advise me where and how to put the external dhcp's with their respective vlans for both flexconnect site(vlan 235) and local site (vlan203)? Please refer to the diagram to have a clear picture.
Also what configuration will I need to do on the WLC Controller GUI.
You help and assistance would be greatly appreciated.
Please do not hesitate to ask questions for clarification.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...