Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring Multiple SSIDs

Hello,

I like to run multiple SSIDs on the same terminal. As the dynamic assignment of VLANs does not work with MBSSID, I try to configure how SSIDL IE. I followed the doc Cisco (Chapter 7) Next, alas my config does not work (in fact, among the clients tested, only one client receives the correct SSID). I upgraded the terminal IOS 12.4 (21a)-JA1 without success. Thank you for your help.

you can find in the attach the configuration.

Could you please help me ?

Best regards

1 REPLY
Hall of Fame Super Silver

Re: Configuring Multiple SSIDs

You have alot of vlans and ssid's.. might cause you issue with older clients or handheld devices.  You check your radius logs to see what the failure are.  Make sure you set the radius attributes correct:

The RADIUS user attributes used for the VLAN ID assignment are:

  • IETF 64 (Tunnel Type)—Set this to VLAN.

  • IETF 65 (Tunnel Medium Type)—Set this to 802

  • IETF 81 (Tunnel Private Group ID)—Set this to VLAN ID.

Scott

-Scott
*** Please rate helpful posts ***
252
Views
0
Helpful
1
Replies
CreatePlease to create content