Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring snmp string for Lightweight AP1242 AG from WLC

We have 1242 AG access points deployed for Wi-Fi access in LWAAP mode. After joining the APs on to the controller we try to configure the SNMP strings for the APs on the WLC but cannot find anywhere to do it.

Is snmp supported in the lightweight AP

if it is, then how I can configure it, via WLC or WCS?

Appreciate any feedback.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Configuring snmp string for Lightweight AP1242 AG from WLC

LAP is different from Autonomous AP, it is stick to the WLC, so you can only configure SNMP for WLC, not for LAP. All the infor about the LAP can be obtained from WLC

2 REPLIES
Bronze

Re: Configuring snmp string for Lightweight AP1242 AG from WLC

LAP is different from Autonomous AP, it is stick to the WLC, so you can only configure SNMP for WLC, not for LAP. All the infor about the LAP can be obtained from WLC

New Member

Re: Configuring snmp string for Lightweight AP1242 AG from WLC

Not without standing on your head (OID-wise)... can I configure a community on the LAP and have it stick once the WLC takes charge?

430
Views
0
Helpful
2
Replies
CreatePlease login to create content