Anyone know how to use the existing Cisco console cable for the model 1200 (9 pin female to RJ45) on the old model 350 with a female 9 pin serial port. I have tried 9 pin adapters with the Cisco console cable.
To compound problems I have laptop with only a USB port no serial interface. This is not a problem for the 1200 console cables and a serial to USB adapter, but it makes this adaptation even more difficult.
The Cisco 1200 console cable is unusable on the model 350. The only cable usable is a straight through 9 pin serial cable with male on one end and female on the other. I had the USB to serial cable already and was hoping to use the console cable from the 1200. This is not possible even with gender changers.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...