Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Control Path to mobility member is down

WISM running 4.2.176

4402 Controller used as Guest Anchor running 5.2.178.0

This has worked fine for some time now. Started getting complaints about guest wireless and noticed that the  Data Path is up and the Control Path is down. From a command line on the WISM eping to the anchor gets a reply where mping does not. Note no changes have been made to the WISM or the Anchor prior to this failure. Any Ideas? Has anyone seen this before?

1 REPLY
New Member

Re: Control Path to mobility member is down

A reboot of the Anchor Controller has resolved the problem for now.

1192
Views
0
Helpful
1
Replies