Conversion of Cisco Aironet series 1231G with RM21A module to Lwapp

[balag1986]

hey folks,

i was wondering whether we can convert the following combo from ios to lwapp.....

1231G with RM21A radio module works fine in autonomous....

Will it work if the same 1231G with RM21A radio module converted to lwapp?

12.3(8)JA2 is IOS software release version the autnomous mode runs....

gone thru the below link.. but its not convincing..

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgr​ade/guide/lwapnote.html​

balag

[balag1986]

suren,

any luck

balag

[Surendra BG · Accepted solution]

case number i cannot pass it on.. its a internal stuff.. only the customer and i can see it.. to clarify ur doubt.. when i used tool to convert the modular radio module which had both G radio and A-radio.. the conversion went well but the AP kept rebooting.. so we consoled into the Ap and tried archive download,.... after which the AP did not relead at all.. and it joined the WLC as well with some SSC issues..

Regards

Surendra

[balag1986]

hmmm... ok..

so to resolve this... we need to use archive download command..

is that correct?

also did you get any tracebacks in the ap when it is rebooting often...

thanks

balag

[Surendra BG]

nope.. we i did not see any tracbacks.. ok.. if ur are getting the tracebacks.. then its AP crashing.. not just rebooting.. open up a tac case for if the customers Aps are generating tracebacks..

Regards

Surendra