Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Converted 1200 LAPs do not failover to secondary WLC

I have 2 4402 WLC's (IOS 5.0.148.2) that support a mix of 1242 and 1200 LAPs. I use DHCP option 43 for the initial location of the WLC's. The problem I have is when I test failover by shutting off the primary controller, all the 1242 APs failover to the secondary controller, but all the 1200s reboot over and over again, without associating to the secondary controller. Once I fire up the primary controller, the 1200s associate and all is good.

Any ideas why this may be happening?

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Converted 1200 LAPs do not failover to secondary WLC

Hi Guillermo,

Maybe the SSC's were not added to the secondary WLC?

Self-Signed Certificate Manual Addition to the Controller for LWAPP-Converted APs

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00806a426c.shtml

Hope this helps!

Rob

3 REPLIES
Hall of Fame Super Red

Re: Converted 1200 LAPs do not failover to secondary WLC

Hi Guillermo,

Maybe the SSC's were not added to the secondary WLC?

Self-Signed Certificate Manual Addition to the Controller for LWAPP-Converted APs

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00806a426c.shtml

Hope this helps!

Rob

New Member

Re: Converted 1200 LAPs do not failover to secondary WLC

Rob,

Thanks so much for pointing me in the right direction! For whatever reason (my fault, I'm sure), the secondary controller had the "Accept SSC" policy disabled. I enabled it and forced one of the 1200's to reassociate, and everything worked!

Thanks again!

Hall of Fame Super Red

Re: Converted 1200 LAPs do not failover to secondary WLC

Hi Guillermo,

You are most welcome my friend :) It only takes a nudge sometimes.

Cheers!

Rob

188
Views
0
Helpful
3
Replies
CreatePlease to create content